Save. Share. Connect.
Wednesday, August 24, 2016
VOLUME - NUMBER
Switches & Relays
HOME / CURRENT ISSUE
Add Message Board
Step Motor Drivers from Applied Motion
Step motor drivers.
Watsonville, CA — Applied Motion Products is introducing the STAC5 step motor driver. The driver provides up to 5 amps per phase from a high bus voltage with sophisticated current control, delivering high torque over a broad range of speeds. An advanced anti-resonance algorithm with electronic damping allows for maximum torque utilization and fast settling times.
The STAC5 is available in 120 and 220VAC versions, both housed in a compact package.
All models include 100Mbit Ethernet communication. The Ethernet interface is used to configure the STAC5 and motor, and also supports the SCL and Q languages over standard Ethernet cabling, addressing and protocols.
The "S" models accept step and direction, analog input, joystick control, and streaming host commands using the SCL language. "S" models include four digital inputs, a 12-bit analog input, and two digital outputs. "Q" models add standalone programmable operation using the "Q" programming language. This versatile language includes high-level features such as complex motion, multi-tasking, conditional programming, math functions, and register access. The "Q" models include 12 digital inputs, a 12-bit analog input, and six digital outputs.
An encoder feedback option provides position verification, stall detection and/or stall prevention. The company's proprietary stall prevention algorithm monitors rotor lag and automatically reduces speed or acceleration to avoid motor stalls, allowing 100 percent torque utilization.
The unit can be ordered with a wide range of high torque step motors, optimized for use with the drive. Three lengths of HT23 are available in single- and double-shaft configurations: HT23-552, HT23-553 and HT23-554, with holding torque ranging from 84 to 255 ounce-inches. Three lengths of HT34 are also available in single- and double-shaft configurations: HT34-495, HT34-496 and HT34-497, with holding torque ranging from 550 to 1700 ounce-inches. All six models include ten foot shielded cables.
Contact: Applied Motion Products, 404 Westridge Drive, Watsonville, CA 95076
800-525-1609 or 831-761-6555 fax: 831-761-6544 E-mail: email@example.com Web:
© 2015 USTECH. All Rights Reserved. |
Contact Us: 610-783-6100 | firstname.lastname@example.org
powered by GIM