Save. Share. Connect.
Wednesday, September 20, 2017
VOLUME -24 NUMBER 8
Publication Date: 08/1/2009
Front Page News
People in the News
Electronic Mfg. Services
Electronic Mfg. Products
Special Features: Test and Measurement
Product Preview: ATE and IPC Midwest
August 2009 Issue
Add Message Board
Nextreme Cools with TEC Eval Kit
Thermoelectric cooling module.
Durham, NC — Nextreme Thermal Solutions has developed an easy-to-use, self-contained platform for conducting desktop demonstrations of its thermoelectric cooling technology. The eTEC
Thermoelectric Cooling Evaluation Kit contains a single UPF40 thermoelectric module, an air-tight cooling environment and electrical connections to make precise temperature measurements of the thin-film thermoelectric device.
In addition to the UPF40 thermoelectric cooler, the evaluation kit consists of a heat sink/fan assembly, a sealed dry-air chamber and two type K thermocouples. The kit provides the full thermal path and requires only an adjustable power supply, a voltmeter, and a two-channel, type K thermocouple readout to measure the temperature differential between the hot and cold sides of the eTEC.
The UPF40 module is suitable for precise cooling and temperature control of opto-electronic applications with high heat-flux requirements in very small packages, including laser diodes, high-brightness LEDs, VCSELs and photo-detectors. It operates with heat fluxes more than 10 times greater than conventional thermoelectric coolers in a fraction of the space. The module can pump a heat density of up to 72W/cm
at 25°C, and as a result, it can move a maximum of 3.7W of heat with an active footprint of only 5.1mm
The module's extremely small footprint opens up new thermal management capabilities in electronics that were previously unavailable. The UPF40 can be embedded directly into electronic packages when and where it's needed to deliver cooling for a wide variety of thermal management applications.
For example, the module can be embedded in a laser diode package to maintain proper operating conditions while improving output levels, reliability and longevity of the laser. The laser can be mounted directly on the UPF40 module providing the ability to precisely cool the laser without the need to cool the entire package, which reduces the overall power budget of the device. Higher wattage lasers can be delivered in smaller and less costly packages.
Contact: Nextreme Thermal Solutions, Inc., 3908 Patriot Dr., Suite 140, Durham, NC 27703-8031
919-597-7300 fax: 919-597-7301 Web:
© 2015 USTECH. All Rights Reserved. |
Contact Us: 610-783-6100 | firstname.lastname@example.org
powered by GIM