Save. Share. Connect.
Tuesday, April 24, 2018
VOLUME -24 NUMBER 6
Publication Date: 06/1/2009
Advertisements
Front Page News
Tech-Op-Ed
Tech Watch
People in the News
Business News
Management
Electronic Mfg. Services
Electronic Mfg. Products
Production
Partnering
Distribution
Special Features: Components and Distribution
Product Preview: Atlantic Design/MDM
New Products
Hi-Tech Events
Calendar
Archive
>
June 2009 Issue
>
Electronic Mfg. Products
>
Add Folder
Add Article
Add Form
Add Message Board
Add Calendar
Add Product
Multi-Seals Epoxy Preforms with Low Outgassing
Preformed seals have low outgassing.
Manchester, CT — Multi-Seals, Inc. has introduced a line of Uni-form epoxy preforms with low outgassing properties. Unlike many adhesives, these highly cross-linked pre-shaped thermoplastics release minimal amounts of trapped gasses or condensable material under vacuum conditions and elevated heat.
Low outgassing properties are essential for aerospace applications, particularly in vacuum environments where volatiles from other adhesives often condense on optics and electronics, adversely affecting their function. With a typical total mass loss of 0.35 percent and typical collected volatile condensable materials of 0.03 percent (tested per ASTM-E-595-93), these low-outgassing epoxies meet NASA requirements for most spacecraft materials.
Uni-forms are pre-shaped, one-part resins that are solid at room temperature. When heated, they melt and cure, forming a consistent seal that protects components from dust, moisture, oil, flux, solvents, conformal coatings, and other contaminants. The seals can be dispensed as rapidly as 200 to 600 parts per minute with little or no operator training, and extensive operator experience is not required to produce uniform results.
Contact: Multi-Seals Inc., 540 North Main Street, Manchester, CT 06042
860-643-7188 fax: 860-643-5669 E-mail: sales@multi-seals.com Web:
http://www.multi-seals.com
search
login
{1}
##LOC[OK]##
{1}
##LOC[OK]##
##LOC[Cancel]##
{1}
##LOC[OK]##
##LOC[Cancel]##