Friday, August 17, 2018
Home/Current Issue >  Industry Articles >  PCB and Manufacturing > 

Robotic Dispensing: Keeping a Lid on Costs

Today's manufacturing processes call for dispensing fluids that include adhesives, acids, alcohol, anaerobic resins, conformal coatings, cyanoacrylates, oils, grease, lubricants, silicones, gels, solder pastes, sealants, solvents and UV adhesives.
Read More

Flux Jet Technology for Lead-Free Soldering

The trend toward environmentally responsible electronics assembly is well-documented. Regulations banning the use of lead, such as Europe's RoHS directive, are driving similar initiatives throughout the world. While many manufacturers have implemented lead-free wave soldering, both ...
Read More

X-ray Inspection of Lead-Free Products

X-ray inspection of PC boards is most often performed using two dimensional x-ray systems. 2D x-ray inspection systems consist of an x-ray source, detector, and a multi-axis manipulation system for object maneuverability. Images are taken and seen "as is" with little to no calculation ...

Read More

Reliability of Embedded Thin-Film NiP Resistors

The use of embedded resistors in multilayer printed circuit boards is increasing at the same time the industry shifts to dielectric materials for lead-free...

Read More

Flex Circuits: Meeting Today's Assembly Challenges

Challenges in the manufacture of electronic assemblies are common in today's "world is flat" environment. They include cultural differences in the workplace, communication, both time and language...

Read More

Small-Batch Automated System on a Budget

If your customers need short runs that call for highflexibility, plus a mix of lead-free and leaded assemblies, it'spossible to satisfy their demands with...

Read More

Budget Priced Systems Meet Small Shop Needs

In spite of the relentless drive toward miniaturization and the increased use of reflow soldering for SMT, there has continued to be a need for wave soldering, even though this process has steadily lost ground to reflow. Continuing miniaturization of products has been the driving force ...
Read More

Heavy Wire Bonding: New Standards, New Machines

Heavy wire bonding is always at risk from residual vibrations. The industry has long been aware of this problem and has been waiting for much needed improvements in heavy wire bonding technology. Movement of the bonder axes can cause the entire assembly to vibrate (residual vibrations) ...

Read More

Embedding ICs Inside PC Boards

The idea of putting components inside the printed wiring board instead of on the surface of the board has been around for at least 30 years, although it has been limited to passive components such as the thin film resistive material made by Ohmega Technologies, and more recently the resistor ...

Read More

Controlling Reflow Oven Cooling Rates

The mandated removal of lead from the environment motivated the surface mount industry to search for a material to replace eutectic tin-lead solder. The new material had to be compatible with most of the existing components while maintaining good electrical conductivity, strength, and ...
Read More

PC Board Makers Must Lead the Revolution

The PC board design cycle process can be divided into four capabilities quadrants: Knowledge; Tools; Libraries; and Manufacturing. At Sunstone, we liken these quadrants to an engineering ecology, or ECOsystem.

Read More

Specifying Fluid Dispensing Equipment

Fluid dispensing and coating processes are required for many assembly and packaging operations. These processes provide combinations of electrical, mechanical, and thermal properties to components and assemblies for functionality or enhanced reliability. Common processes are surface ...
Read More
search login