Save. Share. Connect.
Saturday, December 3, 2016
VOLUME - NUMBER
Switches & Relays
Add Message Board
Ferrite Suppressors from Leader Tech Snap On
Tampa, FL — Bisected FerriShield Ferrite suppressors from Leader Tech are available in a wide assortment of styles and sizes and can quickly be snapped onto a cable that has already been terminated. The company offers hundreds of frequency-specific ferrite solutions for both round and flat cables.
On a daily basis, there are millions of electronic devices that operate in close proximity on a very narrow portion of the wireless communications spectrum that spans from 30Hz to 300GHz. Due to antenna size, power, range, cost constraints and stringent FCC regulations, most of our personal electronics crowd an even a smaller portion of that spectrum (5GHz and below). Therefore any uncontrolled electromagnetic radiation in this frequency range can interfere with the normal operation of your electronic device. Control of electromagnetic and radio frequency interference (EMI/RFI) is a major engineering concern for all electronics manufacturers. Unfortunately, many of these problems are not known until the costly, testing stage of development. In many instances, it is discovered that a data cable or even power cord is acting as an antenna, causing unacceptable levels of interference to spill into the environment.
One of the easiest and most cost-effective solutions for this type of shielding problem is to attach a ferrite suppressor to the origination and/or termination ends of your cables.
Contact Leader Tech, 12420 Race Track Rd., Tampa, FL 33626
813-855-6921 fax: 813-855-3291 E-mail: firstname.lastname@example.org Web:
© 2015 USTECH. All Rights Reserved. |
Contact Us: 610-783-6100 | email@example.com
powered by GIM