|JENA, Germany - |
GOEPEL electronic introduces SFX-TAP16/G-RM, a new version of its TAP Transceiver for the test and programming of up to 16 electronic assemblies in parallel. The compact solution with integrated system power supply helps to increase the throughput for UUT (unit under test) with a single TAP (test access port) by factor 16, which results in significantly improved production efficiency and reduced investment costs. Thanks to the TAP interfaces’ programmability (voltage, delay, protocol, etc.) and the TAP-to-UUT assignments’ individual configurability, the system can be flexibly customized to fit nearly any environment and application.
“Our OEM, ODM, and EMS customers show constantly growing interest in solutions for high-speed programming of Flash through processor debug interface or with an FPGA-embedded programmer in order to increase throughput. This new addition to our SCANFLEX hardware portfolio additionally ensures the utilization of dynamic tests based on processor emulation in production lines or stress tests in climatic chambers“, says Thomas Wenzel, Managing Director of GOEPEL electronic’s Boundary Scan Division. “The detection of latent defects in particular in HASS/HALT procedures becomes more and more important for many test and production scenarios. Hence, our SFX-TAP16-G-RM is a logical consequence in providing new technologies for maximum fault coverage.”
The SFX-TAP16/G-RM, available as rack mount version in 19’’ technology (1U), provides 16 parallel TAPs. Its architecture supports all modern Embedded System Access (ESA) technologies, including boundary scan, processor emulation, and chip-embedded instrumentation, enabling the basic paradigm change for test and programming methods without mechanical probe access (non-intrusive). This new SCANFLEX module was developed specifically for Gang applications, whereby various test and programming strategies can be freely combined.
The new transceiver can be flexibly adapted to the UUT characteristics; its bandwidth reaches from concurrent test/programming of 16 UUTs with a single TAP to two UUT with eight TAP each. In addition, the TAPs can be individually programmed in many parameters.
Sales Contact USA:
GOEPEL electronics LLC,9737 Great Hills Trail, Ste. 170, Austin, TX 78759,Tel.: +1 512 782 2500,Fax: +1 734 471 1444, Email: email@example.com , Web: www.goepelusa.com