Norwood, MA — The new CLWT-115 research quality, closed loop wind tunnel from Advanced Thermal Solutions reportedly provides an accurate and convenient system for thermally characterizing PCBs, heat sinks and components at controlled temperatures from ambient to 85°C (185°F).
|Closed-loop wind tunnel test system. |
The CLWT-115 wind tunnel produces air flows up to 5m/s (1,000-ft/min). Using optional orifice plates it can generate flows up to 50m/s (10,000-ft/min). The instrument's clear Lexan test section provides a continuous view of the test specimens, as well as flow visualization studies, such as using smoke or vapor.
Unlike open-loop wind tunnels, the CLWT-115 recirculates internal air. This allows the system heater to quickly warm the air to a specific temperature. The testing of boards and components in hot air is a requirement in some NEBS and other standards. The precise controls and temperature range of the CLWT-115 wind tunnel allows its use for testing heat sink performance and for calibrating air and temperature sensors.
The wind tunnel provides a generous test section measuring 77.6 x 26 x 11.6cm (30.5 x 10.2 x 4.55-in.). This chamber can be accessed from the top or sides for mounting and repositioning boards, components and sensors. Internal rail guides provide an easy system to install test specimens of different sizes such as PCBs and heat sinks. Six instrument ports in the side walls of the test section are for temperature and velocity sensors such as thermocouples, Pitot tubes and hotwire anemometers.
A complete system fits on most lab benches and is powered from standard AC power outlets. Its footprint is smaller than traditional, closed-loop wind tunnels or environmental test chambers.
Contact: Advanced Thermal Solutions, 89-27 Access Rd., Norwood, MA 02062 781-769-2800 fax: 781-769-9979 Web: http://www.qats.com